4kq G60 conversion part two.
This is an addendum to the other post I had "4kq G60 Conversion". It was spurred on by Chris Woodward actually doing the conversion on his CGT with 90FWD struts. Here is his email to me:

05 Dec 2001
Mark, regarding http://www.mchang.org/audi/tech/4kg60conversion.html -- I'm glad I found this page on your site... it helped me confirm that I can bolt the G60s to my Coupe GT with 90FWD struts.

Couple of corrections you might want to make:

• The 276mm rotor p/n is listed incorrectly. The one shown is the 256mm for the 90Q20V sedan. The correct rotor p/n is 893 615 301.
• Swapping of the wheel bearing & hub should not be necessary if you get struts from a FWD 80/90. The 80/90Q however uses a stretch bolt rather than a nut threaded onto the CV, so if the donor car was a Q the page is correct.
• I haven't checked yet but I believe you'd need brake lines from a 5kt to complete this conversion.
  

Can't wait to get these G60s bolted up to this light car! Take it easy,
Chris